save_and_recall ¶

The save_and_recall commands module.

These commands are used in the following models: DPO2K, DPO2KB, DPO4K, DPO4KB, DPO5K, DPO5KB, DPO70KC, DPO70KD, DPO70KDX, DPO70KSX, DPO7K, DPO7KC, DSA70KC, DSA70KD, MDO3, MDO3K, MDO4K, MDO4KB, MDO4KC, MSO2K, MSO2KB, MSO4K, MSO4KB, MSO5K, MSO5KB, MSO70KC, MSO70KDX

THIS FILE IS AUTO-GENERATED, IT SHOULD NOT BE MANUALLY MODIFIED.

Please report an issue if one is found.

Commands and Queries

- *RCL <NR1>
- *SAV <NR1>

Rcl ¶

Bases: SCPICmdWrite

The *RCL command.

Description

This command restores the state of the oscilloscope from a copy of the settings stored in memory (The settings are stored using the *SAV command).

Usage

Using the .write(value) method will send the *RCL value command.

SCPI Syntax

- *RCL <NR1>

Info

<NR1> is a value in the range from 1 to 10, which specifies a saved setup storage location.

Sav ¶

Bases: SCPICmdWrite

The *SAV command.

Description

Stores the state of the oscilloscope to a specified memory location. You can use the *RCL command to restore the oscilloscope to this saved state at a later time.

Usage

Using the .write(value) method will send the *SAV value command.

SCPI Syntax

- *SAV <NR1>

Info

<NR1> specifies a location in which to save the state of the oscilloscope. Location values range from 1 through 10. Using an out-of-range location value causes an execution error. Any settings that have been stored previously at this location will be overwritten.