status_and_error ¶

The status_and_error commands module.

These commands are used in the following models: AWG5200, AWG5K, AWG5KC, AWG70KA, AWG70KB, AWG7K, AWG7KC, DPO2K, DPO2KB, DPO4K, DPO4KB, DPO5K, DPO5KB, DPO70KC, DPO70KD, DPO70KDX, DPO70KSX, DPO7K, DPO7KC, DSA70KC, DSA70KD, MDO3, MDO3K, MDO4K, MDO4KB, MDO4KC, MSO2, MSO2K, MSO2KB, MSO4K, MSO4KB, MSO5K, MSO5KB, MSO70KC, MSO70KDX, TekScopePC

THIS FILE IS AUTO-GENERATED, IT SHOULD NOT BE MANUALLY MODIFIED.

Please report an issue if one is found.

Commands and Queries

- *ESE <NR1>
- *ESE?

Ese ¶

Bases: SCPICmdWrite, SCPICmdRead

The *ESE command.

Description

This command sets and queries the bits in the Event Status Enable Register (ESER). The ESER prevents events from being reported to the Status Byte Register (STB). For a more detailed discussion of the use of these registers, see Registers.

Usage

Using the .query() method will send the *ESE? query.
Using the .verify(value) method will send the *ESE? query and raise an AssertionError if the returned value does not match value.
Using the .write(value) method will send the *ESE value command.

SCPI Syntax

- *ESE <NR1>
- *ESE?

Info

<NR1> specifies the binary bits of the ESER according to this value, which ranges from 0 through 255.