pause ¶

The pause commands module.

These commands are used in the following models: DPO4K, DPO4KB, DPO7AX, LPD6, MDO3, MDO3K, MDO4K, MDO4KB, MDO4KC, MSO2, MSO4, MSO4B, MSO4K, MSO4KB, MSO5, MSO5B, MSO5LP, MSO6, MSO6B, TekScopePC

THIS FILE IS AUTO-GENERATED, IT SHOULD NOT BE MANUALLY MODIFIED.

Please report an issue if one is found.

Commands and Queries

- PAUSe <NR3>

Pause ¶

Bases: SCPICmdWrite

The PAUSe command.

Description

This command causes the interface to pause the specified number of seconds before processing any other commands.

Usage

Using the .write(value) method will send the PAUSe value command.

SCPI Syntax

- PAUSe <NR3>

Info

<NR3> is the specified number of seconds the interface is to pause before processing any other commands. The pause time is specified as a floating point value in seconds and must be > 0.0 and ≥1800.0.